3D model of 3dcentralva
The models were repaired and checked for printability.
This is an extension from the popular octopus thick legs. We made room for a magnet
...Show more to fit, such that it will be snug to your fridge.
It was made to fit with 1/2-Inch by 1/16-Inch Rare Earth Disc Magnets
1. Print the STL with minimal support.
2. On the magnet hole on the underside of the octopus, either apply superglue or a few drops of acetone.
3. Insert magnet -- but be careful! it's a snug fit, so especially in the case of acetone, beware the acetone might splash out (you do not want this in your eyes)
https://www.facebook.com/carry.the.what.replications
