3D model of tomstanton
The models were repaired and checked for printability.
Frame:
2pcs 4040 600mm Extrusions
1pcs 4040 300mm Extrusion
4pcs M5x20 Bolts
4pcs
...Show more M5x10 Bolts
(Extrusion ends must be tap threaded for M5 bolts)
Joystick:
1pcs 2020 300mm Extrusion (lengths can be adjusted for different chair heights)
1pcs 2020 200mm Extrusion
4pcs 10x26x8mm Bearings (Inside diameter x Outside diameter x Width)
2pcs M10x20 Shoulder Bolts (10mm shoulder, 8mm thread)
2pcs M10x10 Shoulder Bolts (10mm shoulder, 8mm thread)
8pcs M5x10 Bolts
7pcs M5x14 Bolts
14pcs M5x20 Bolts
16pcs M5 T-slot Nuts
4pcs 75x10x1.25mm Springs (Length x Outside Diameter x Wire Diameter)
2pcs 8mm cube magnets
2pcs Hall Effect Sensor SS496A1
1pcs Push button
Throttle + switches:
2pcs M5x10 Bolts
4pcs M3x10 Bolts
2pcs M5 T-slot Nuts
1pcs M5 Grub Screw (To clamp the potentiometer shaft)
4pcs Toggle Switches
1pcs Push button
1pcs 10k Potentiometer
Rudder Pedals:
2pcs 2020 150mm Extrusions
3pcs M8x30 Shoulder Bolts
6pcs 10x26x8mm Bearings
4pcs M5x14mm Bolts
22pcs M5x20mm Bolts
16pcs M5 T-slot Nuts
2pcs M5x100mm Bolts
2pcs M5 100mm Threaded Rod
4pcs M5 Female Rod ends
2pcs 75x10x1.25mm Springs (Length x Outside Diameter x Wire Diameter)
2pcs 8mm cube magnets
1pcs Hall Effect Sensor SS496A1
Arduino Case:
2pcs M5x14 Bolts
2pcs M5 T-slot Nuts
2pcs M3x10 Bolts
Other Electronics:
Arduino Micro (must be 32u4 processor)
USB lead
30awg wire (Atleast 10m total, but preferably different colours for power/ground/signal etc)
https://www.instagram.com/tom__stanton
