3D model of aubenc. The models were repaired and checked for printability.
I just couldn't resist to openscad this...
The OpenSCAD is not a wonder but it
...Show more will allow you to play with a few parameters, not very well commented and weirdly named. My apologizes :-P
I was setting the wall width parameter to 1mm for the "thin walls" stl. It worked fine to me but it may not be the case for you (check it out before printing!). The walls are set to 3mm for the other v2 .stl
"Thin walls" printed in less than 1h (26mm/s) vs more than 2h for the other one(22mm/s). In the other hand, "thin walls" has sharp edges (look at the bottom).
If you use the OpenScad (please do it!) you'll need to use the center and rotate (?) features of ReplicatorG/your software of choice.
The middle ring has been flattened using a 0.85 scale that's lost somewhere in the code !! (2nd circle in the "outer_shape()" module)
I guess I'm forgetting something that should also be said...
