tfelty notes:
I found tgoacher's cyclotron and wanted to modify it for a Real Ghostbusters pack.
I've modified the top pieces to have the hole in the
...Show more middle of the bottom covers. To fit the LED holders in, you can either modify the models farther or my plan is to cut the part that collides.
To Build Print the following:
Print two copies of CyTopWide.stl
Print one copy of CyTop_rgb_left.stl & one copy of CyTop_rgb_left.stl
Print two copies of CyBottomWide.stl
Print two copies of CyBottomNarrow.stl
Print four copies of CyDisk.stl
Optionally print 3 copies of LedDiffuser.stl in clear PLA. This fits a
5mm LED.
From tgoacher's project:
UPDATE 2/12/17. This part was used in the Ghostbusters Station 6 fan film. Check it out on youtube at https://www.youtube.com/watch?v=RHMUsQqLmRg
RE:UPDATE 4/12/15 New mount will need holes for self tappers to be drilled into the bottom of the cylo. I will make changes to fix this soon.
UPDATE 4/12/15: New cyclo mount added. This is an improved, single mount over the 4 separate ones previously and aligns with the holes in:
https://www.thingiverse.com/thing:1093376
I need to update the cyclo bases to match the holes in the mount, or in the meantime, use a 2.5mm drill with the mount against the base of the cyclotron as a drill template.
A full size, 3D printable version of the Ghostbusters' Proton Pack cyclotron based on Steffan Otto's plans at:
http://www.gbfans.com/wiki/Stefan_Otto%27s_Prop_Plans
Print two copies of CyTopWide.stl
Print two copies of CyTopNarrow.stl_Replaced with RGB Versions
Print two copies of CyBottomWide.stl
Print two copies of CyBottomNarrow.stl
Print four copies of CyDisk.stl
Optionally print 4 copies of LedDiffuser.stl in clear PLA. This fits a
5mm LED.
Join bottom parts together using M4 nuts and bolts.
Push CyDisks through CyTop holes, then fasten to CyBottom from
underneath with 5/8"x#3 self tap screws.
Print drill.pdf onto A3 paper at 'actual size' for the drill centres for
holes.
Print 1x CyBottomNarrow.stl and 1xCyclo-NFilter if you plan to
use my N-Filter at:
http://www.thingiverse.com/thing:543816
UPDATE 20/11/2014: Added pillars to allow the cyclo disk to fasten directly to the motherboard. See CAD rendering for details.
